SN900

On this product, data is stored on an internal hard disk.

Dismantling

  • Using the Phillips screwdriver, unscrew the 2 black countersunk screws at the back of the cover.
 
  • Remove the cover by sliding it backwards. This operation will tear the warranty sticker.

IMPORTANT

Closely follow the instructions and precautions for handling the hard disk set out in the vendor’s installation guide.

 

  • Locate the hard disk. Remove the adhesive strip and unplug the SATA connector from the hard disk.
  •  

  • Using the Phillips screwdriver, unscrew the 4 fastening screws from the hard disk support, keeping the associated hex spacer in place with a flat wrench.
  •  

  • Remove the hard disk & support setup.
  •  

  • Using the Phillips screwdriver, unscrew the 4 lateral screws of the hard disk. Remove the hard disk.

Assembling

  • Put the support back on its 4 spacers, with the vibration absorbers in place.
  • Fasten the support using the 4 screws. Use one of these 4 screws to fasten the free ring terminal of the cable connecting the support + hard disk setup to the chassis.
  • Check that the 4 lateral screws of the hard disk remain outside the chassis. Place the cover back on and close it up using the 2 screws.