SN510, SN710 and SN910

On these products, data is stored on an internal hard disk.

Dismantling

 
  • Using the Phillips screwdriver, unscrew the 2 black countersunk screws at the back of the cover as well as the 10 black countersunk screws that hold the lateral brackets in place.
   
 
  • Remove the cover by sliding it backwards. This operation will tear the warranty sticker.

IMPORTANT

Closely follow the instructions and precautions for handling the hard disk set out in the vendor’s installation guide.

 

 

     

  • Locate the hard disk. On the hard disk, remove the adhesive strip and unplug the SATA connector (SN510 and SN710) or the SATA connector and the hard disk's power plug (SN910).

  •  

  • Using the Phillips screwdriver, unscrew the 4 fastening screws from the hard disk support.

     

  • Remove the hard disk & support setup.
   
 
  • Unscrew the 4 lateral screws of the hard disk. Remove the hard disk.

Assembling

  • Put the support back on its 4 spacers, with the vibration absorbers in place.
  • Fasten the support using the 4 screws. Use one of these 4 screws to fasten the free ring terminal of the cable connecting the support + hard disk setup to the chassis.
  • Check that the 4 lateral screws of the hard disk remain outside the chassis. Place the cover back on and the lateral fastening brackets, and close it up using the 12 screws.